Replace The Card Cage Filter - Christie Solaria One User Manual

7. Align the ring terminal on the anode wire (2) with the mounting position ensuring the crimped side of the
wire is facing out. Tighten the anode screw. NOTE: Route anode lead away from nearby metal surfaces.
8. Close the lamp access door and tighten the 2 thumbscrews.
9. Close the firewall door and tighten the 2 thumbscrews.
10. Close and lock the rear access door. NOTE: Ensure the hex key is placed back into its holder before
closing the rear access door.
11. Connect the projector to AC power and then turn the projector on.
12. Tap Menu > Advanced Setup > Lamp Change Wizard.
13. Tap Next.
14. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
15. Tap Save.
16. Tap Next.
17. Align the lamp. See

15.5 Replace the Card Cage Filter

without the filter installed. Always discard used air filters.
You should check the condition of the card cage air filter
monthly. Replace the card cage air filter sooner if you are
operating the projector in a dusty or dirty environment. The
filter is located on the left side of the projector behind the air
filter cover.
1. Loosen the 2 captive screws on the bottom of the filter
cover.
2. Pull the cover out and down.
3. Slide the air filter out and discard. Insert the new air filter
with the airflow indicator facing toward the projector.
4. Install the air filter cover by inserting the 2 bottom tabs and then pushing the door closed.
5. Tighten the 2 captive screws.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
Description
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement. This field
is auto-populated.
The number of hours the lamp has operated before installation.
Align the Lamp on page
Use only high efficiency Christie approved filters. Never operate the projector
1-18.
15-5