Inspecting The Card Cage Filter; Inspecting The Light Engine Compartment Filter - Christie CP2208 User Manual

1. Brush most of the dust off with a camelhair brush or use a dust-free blower.
2. Wrap a lens tissue around a swab and soak it in lens cleaning solution.
The tissue should be damp but not dripping. Do not use a cleaning solvent that contains
ammonia. Avoid lens contact with Xylene and Ether.
3. Gently wipe the surface using a figure eight motion.
4. Repeat until the blemish is removed.

Inspecting the card cage filter

Check the condition of the card cage air filter monthly. Clean or replace the card cage air filter sooner
if you are operating the projector in a dusty or dirty environment.
The filter is located on the left side of the projector behind the air filter cover. Use only high efficiency
Christie approved filters.
1. Loosen the two captive screws on the bottom of the filter cover.
2. Pull the cover out and down.
3. Slide the air filter out and inspect it.
If the filter appears dirty and you cannot see through it, clean it (on page 80).
If the filter appears clean, continue to step 4.
4. Replace the air filter with the airflow indicator facing toward the projector.
5. Install the air filter cover by inserting the two bottom tabs and then pushing the cover closed.
6. Tighten the two captive screws.

Inspecting the light engine compartment filter

The filter is located on the right side of the projector behind the service access panel.
1. Remove the top lid.
2. Reach into the projector and then loosen the first service panel screw.
3. Open the integrator rod access door and loosen the second service panel screw.
4. Push the clips on the top of the service panel down and out to remove the service panel.
CP2208 User Guide
020-101916-03 Rev. 1 (12-20120)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Maintaining the projector
78