Adding The Projector To A Network - Christie CP2208 Installation And Setup Manual

firewall is unbroken, the projector is unaltered, and to tap the marriage button on the card cage
faceplate.
1. Log on to the projector with marriage permissions. See
21.
2. Tap Menu > Service Setup > IMB Marriage.
3. Complete the Marriage wizard.
4. Click Finish.

Adding the projector to a network

1. On the touch panel controller (TPC), tap Menu > Login.
2. Select an administrator account in the Username list.
3. Enter a password in the Password field and then tap Login.
4. Tap Menu > Administrator Setup > Communications Configuration.
5. Complete these fields:
Field
Device Name
IP Address
Subnet Mask
Gateway
Apply
Serial Speed (Baud)
Enable SNMP
SNMP V2 / SNMP V3
Management IP
CP2208 Installation and Setup Guide
020-102031-01 Rev. 1 (09-2015)
Description
The name of the projector.
The IP address of the projector.
The subnet mask to which the address belongs.
The IP address for the network gateway.
Applies Ethernet settings.
The baud rate of the serial port. The default is 115200.
Enables SNMP.
The SNMP protocol type. Contact Christie for the SNMP V3 user ID and
password.
The IP address where SNMP information and notifications are sent.
Logging on to the projector on page
22