Tools (Administrator Mode); Tools Overview - Xerox Versant 80 Press System Administration Manual

Tools (Administrator Mode)

Tools Overview

The following summarizes the various options from Machine Status > Tools on the
press UI that can be set or used while logged in as administrator.
When you press the Tools tab while in the Administrator mode, the following features
are available for selection:
Cleaning the Fuser Assembly - If needed, run this image quality procedure to clean
and remove dry ink/toner debris that may appear on the back side of prints.
DFA Finisher Profile - If the press includes a third-party, DFA inline finishing devices,
this feature is enabled to create a profile of the finisher and add, edit, and / or delete
its attributes.
Simple Image Quality Adjustment (SIQA) Tools - This is a set of procedure that are
used to correct and adjust alignment, density uniformity, and image quality transfer
on prints. Refer to the
Tools - Select the Tools tab on the UI to access other areas where you can set system
functions and security settings, including the following:
- System Settings: Refer to
procedures.
- Setup & Calibration: Refer to
procedures.
- Accounting: Refer to
- Authentication / Security Settings: Refer to
for detailed information and procedures.
Note
Use the up/down scroll buttons on the screens to view the entire list of options.
Xerox ® Versant ® 80 Press
System Administration Guide
SIQA chapter for detailed information and procedures.
System Settings
Setup & Calibration
Accounting for detailed information and procedures.
for detailed information and
for detailed information and
Authentication / Security Settings
3
3-1