Internet Protocol Security (Ipsec); Ipsec; Configuring Ipsec - Xerox Versant 80 Press System Administration Manual

Configure CentreWare Internet Services Settings

Internet Protocol Security (IPsec)

IPsec

Internet Protocol Security (IPsec) is a group of protocols used to secure Internet Protocol
communications by authenticating and encrypting each IP data packet. It allows you
to control IP communication by creating protocol groups, policies, and actions for the
following:
DHCP v4/v6 (TCP and UDP)
DNS (TCP and UDP)
FTP (TCP)
SMTP (TCP/UDP port 25)
HTTP (Scan Out, TCP port 80)
SNMP (TCP/UDP port 161)
HTTPS (Scan Out, TCP port 443)
SNMP Traps (TCP/UDP port 162)
HTTPS (Web Server, TCP port 443)
IPP (TCP port 631)

Configuring IPSec

Note
Secure HTTP (SSL) must be enabled with an installed digital certificate before you can
enable IPsec.
1. In CentreWare Internet Services, click Properties > Security > IPSec.
2. Next to Protocol, select Enabled.
3. Select the IKE Authentication Method, Preshared Key or Digital Signature.
4. If you select Preshared Key, type the Shared Key and retype the key to verify.
5. Type the IKE SA Life Time (5-28800 minutes).
6. Type the IPSec SA Life Time (300-172800 minutes).
7. Select the DH Group type.
8. Enable PFS if necessary.
9. Type the Specific Destination IPv4 Address.
10. Type the Specific Destination IPv6 Address.
11. To restrict the press from communicating with devices that are not using IPSec, select
Disabled next to Communicate with Non-IP Sec Device.
12. Click Apply to accept the changes or Undo to retain the previous settings.
10-32 Xerox ® Versant ® 80 Press
System Administration Guide