Xerox Versant 80 Press System Administration Manual page 120

Setup and Calibration (Tools Administrator Mode)
b) Select Watermark.
c) Select Date & Time.
d) Select Add.
e) Select Save.
10. Press the Start button.
If no name is entered for the newly stored program, the name automatically becomes
(No Name).
This ends the job and saves (store) the programming. When you run this stored
program at a later time, the stored program displays all the required screens prior to
job submission.
Deleting a Stored Program
1. Press the Machine Status button on the press UI.
2. Select the Tools tab.
3. Select Setup & Calibration > Setup > Stored Programming .
4. Select Delete.
5. Select the stored program number you want to delete.
A message displays on the UI asking you to confirm whether or not you want to
delete the selected stored settings.
6. Select Delete to confirm stored programming deletion.
7. Select Close to exit Stored Programming.
Note
Deleted stored programs cannot be restored.
Naming / Renaming a Stored Program
1. Press the Machine Status button on the press UI.
2. Select the Tools tab.
3. Select Setup & Calibration > Setup > Stored Programming .
4. Select Enter / Change Name.
5. Select the stored program that you want to name or rename.
6. Enter the name.
A maximum of 36 characters is allowed for a stored program name.
7. Select Save.
8. Select Close to exit Stored Programming.
Assigning or Changing Icons for a Stored Program
1. Press the Machine Status button on the press UI.
2. Select the Tools tab.
3. Select Setup & Calibration > Setup > Stored Programming .
4. Select Assign / Change Icon.
5. Select the stored program to add or change the icon.
6. Select an icon.
There are 12 icons from which to choose.
6-8 Xerox ® Versant ® 80 Press
System Administration Guide