Store To Folder; Configuring The Store To Folder Environment Settings; Enabling Ports And Setting Up Tcp/Ip - Xerox Versant 80 Press System Administration Manual

Store to Folder

Configuring the Store to Folder Environment Settings

This section describes configuration procedures to use the Store to Folder service on the
device.

Enabling Ports and Setting up TCP/IP

Using Network Scanner Utility 3 (Scan Driver and Stored File Manager), which supports
WebDAV protocol, and the EasyOperator application, enable the SNMP, SOAP, and
WebDAV ports and set up an IP address.
Note
The ports and TCP/IP configuration also can be performed using CentreWare Internet
Services. Refer to Configure CentreWare Internet Services
1. Login as the Administrator.
2. Press the Machine Status button on the press User Interface (UI).
3. Select the Tools tab on the UI.
4. Select System Settings.
5. Select Connectivity & Network Setup > Port Settings .
6. Select SMNP.
a) Select Change Settings.
b) Select Port Status then select Change Settings.
c) Select Enabled, and then select Save.
d) Select Close until the Port Settings screen is displayed.
7. Select SOAP.
a) Select Change Settings.
b) Select Port Status then select Change Settings.
c) Select Enabled, and then select Save.
d) Select Close until the Port Settings screen is displayed.
8. Select WebDAV.
a) Select Change Settings.
b) Select Port Status then select Change Settings.
c) Select Enabled, and then select Save.
d) Select Close until the Port Settings screen is displayed.
9. Select Close until the main Tools screen displays.
10. If necessary, set the IP Address; choose one of the following:
To set an IP address, refer to
If an IP address is already set, skip this step.
Xerox ® Versant ® 80 Press
System Administration Guide
Configure Environment Settings for Scan Services
Settings.
Connectivity & Network Setup.
11-13