Configuring The Snmp Port; Scan To Pc; Configuring The Scan To Pc Environment Settings - Xerox Versant 80 Press System Administration Manual

Configure Environment Settings for Scan Services
11. Print a configuration report to confirm that all the ports are enabled and that TCP/IP
is set up correctly.

Configuring the SNMP Port

1. Connect to CentreWare.
2. Configure the transport protocol for the SNMP port.
a) Click on the Properties tab.
b) Click on Connectivity.
c) Click on Port Settings.
d) Select the UDP check box under SNMP.
e) Click Apply.
f) Enter the system administrator user ID and passcode and click OK.
The right frame of the web browser page changes to the machine reboot display.
g) Click Reboot Machine.
The machine reboots and the settings are enabled.

Scan to PC

Configuring the Scan to PC Environment Settings

This section describes how to configure the machine to use the Scan to PC service.
Requirement Information
The following items are required to use the Scan to PC feature.
11-10 Xerox ® Versant ® 80 Press
System Administration Guide