Adjusting The Seat Depth Without Replacing The Seat Support Plate - Invacare FDX User Manual

Invacare® FDX®
- If the seat support plate does need to be replaced,
please refer to chapter 5.14.4 Adjusting the seat depth
with replacing the seat support plate, page 57.
5.14.3 Adjusting the seat depth without replacing the
seat support plate
Fig. 5-30 Exploded drawing of seat support
Disassembly
1. Remove the armrests.
2. Remove the seat cushion.
3. Remove the cover plates (1).
4. Undo and remove the two Allen screws (8) which are
located on the side at the rear of the seat support plate,
and connect these to the crossmembers (4).
56
5. Repeat these operations on the other side of the seat.
6. Undo and remove the two Allen screws (5) including
washers.
Assembly
1. Pull the seat support to the required length so that
the Allen screws (5) can be inserted in the holes in
accordance with the table (see above).
2. Insert the Allen screws (5) including washers again and
tighten them.
3. Fit the two Allen screws (8) which are located at the
rear of the seat support, and connect them with the
crossmembers (4). You must be using other holes within
the 3 hole pairs for the screws than you did during
dismantling.
4. Refit all the parts you have removed.
1541361-N