Adjusting The Seat Depth Without Replacing The Seat Support Plates; Adjusting The Seat Depth And Replacing The Seat Support Plates - Invacare Storm Service Manual

8.9.2.1

Adjusting the seat depth without replacing the seat support plates

•
Remove the armrests.
•
Remove the seat cushion.
• Remove the cover plates (1).
•
Loosen and remove the two Allen screws (8) on the rear side of the seat support plate
connecting this to the cross braces (4).
•
Repeat this work step on the other side of the seat.
•
Loosen and remove the two Allen screws (5) incl. the washers.
Assembly:
•
Pull the seat support to the desired length so that the Allen screws (5) can be placed in the
holes according to the table (see above).
•
Refit the Allen screws (5) incl. the washers and tighten them.
•
Fit the two Allen screws (8) on the rear side of the seat support, connecting this to the cross
braces (4). Unlike dismantling, different holes in the three pairs of holes must be used for the
screws.
•
Refit all parts that were removed.
•
If necessary, replace the splash guards as described in chapter 8.1.5.
8.9.2.2

Adjusting the seat depth and replacing the seat support plates

Disassembly:
•
Remove the legrests.
•
Remove the armrests.
• Remove the seat cushion.
•
Remove any existing cable ties holding the remote or lighting cables. Release the cables from
the stuck on clamps.
•
Loosen the cap nuts of the headlight mountings using an 8 mm jaw spanner (see chapter
8.2.5 or Fehler! Verweisquelle konnte nicht gefunden werden.).
•
Put the headlights and the mounting in a safe place on the rear part of the battery
compartment cover.
• Remove the cover plates (1).
•
Loosen the two Allen screws (9) at the top front of the seat support plate and remove them.
•
Loosen the two Allen screws (7) on the front side of the seat support plate connecting this to
the cross braces (4).
•
Loosen the two Allen screws (8) on the rear side of the seat support plate, connecting this to
the cross braces (4).
•
Remove the seat support plate (2).
•
Repeat this work step on the other side of the seat.
• Loosen and remove the two Allen screws (5) incl. the washers.
•
Pull the seat support to the desired length so that the Allen screws (5) can be fitted into the
holes according to the table (see above).
•
Refit the Allen screws (5) incl. the washers and tighten them.
89