Adjusting The Seat Depth Without Replacing The Seat Support Plate - Invacare Storm4 X-plore User Manual

Invacare® Storm®⁴ Series
to chapter 5.11.4 Adjusting the seat depth with replacing the seat
support plate, page 53.
5.11.3 Adjusting the seat depth without replacing
the seat support plate
Exploded drawing of seat support
Disassembly
1. Remove the armrests.
2. Remove the seat cushion.
3. Remove the cover plates (1).
4. Undo and remove the two Allen screws (8) which are located
on the side at the rear of the seat support plate, and connect
these to the crossmembers (4).
52
5. Repeat these operations on the other side of the seat.
6. Undo and remove the two Allen screws (5) including washers.
Assembly
1. Pull the seat support to the required length so that the Allen
screws (5) can be inserted in the holes in accordance with the
table (see above).
2. Insert the Allen screws (5) including washers again and tighten
them.
3. Fit the two Allen screws (8) which are located at the rear of the
seat support, and connect them with the crossmembers (4). You
must be using other holes within the 3 hole pairs for the screws
than you did during dismantling.
4. Refit all the parts you have removed.
1529686-R