Ip Http Authentication - Dell N1100-ON Reference Manual

• encrypted — Encrypted password entered, copied from another switch
configuration.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The Dell EMC Networking firmware emulates industry standard behavior for
enable mode authentication over SSH and telnet. The default enable
authentication method for telnet and SSH uses the enableNetList method,
which requires an enable password. If users are unable to enter privileged
mode when accessing the switch via telnet or SSH, the administrator will
need to either change the enable authentication method, e.g. to enableList,
or set an enable password. If the encrypted parameter is specified, the
password parameter is stored as entered in the running-config. No attempt is
made to decode the encrypted password. To use the ! character as part of the
username or password string, it should be enclosed within quotation marks.
For example, username "test!xyz" password "test!xyz".
Example
The following example defines password "xxxyyyzzz" to control access to user
and privilege levels.
console(config)# enable password xxxyyyzzz

ip http authentication

Use the ip http authentication command in Global Configuration mode to
specify authentication methods for http server users. To return to the default,
use the no form of this command.
Syntax
ip http authentication method1 [method2...]
no ip http authentication
Security Commands
865