Disassembly And Replacement - Toshiba e-STUDIO520 Service Manual

13.5 Disassembly and Replacement

[A] Transfer unit
(1) Open the front cover and take out the trans-
fer/transport unit by turning the lever clock-
wise.
(2) Remove 1 screw to take off the handle.
(3) Remove 2 screws to take off the cover.
(4) Disconnect 2 connectors. (Raise the belt
when disconnecting the connector on the
right side.)
(5) Remove 1 clip and slide the bearing on the
front side to inside.
(6) Remove 4 screws.
(7) Slide the transfer unit to the rear side and
raise the front side to take it off.
e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT
Screw
Screw
Bearing Clip
Screw
13 - 6
Transfer/transport unit
Fig.13-3
Cover
Handle Screw
Fig.13-4
Screw
Connector
Screw
Fig.13-5
March 2005 © TOSHIBA TEC