Toshiba e-STUDIO520 Service Manual page 146

(5) Rotate the carriage-1 in the direction shown
in the figure at right, paying attention not to
touch the mirror. Then take out the carriage-
1.
Note:
When installing the carriage-1, fix its bracket
temporarily at the cutout of the frame. After
that, move the carriage until it touches the
left side of the frame, and then tighten 2
screws to fix it permanently.
[I] Carriage-2
(1) Take off the carriage-1
( P.6-21 "[H] Carriage-1").
(2) Install the wire holder jig on the wire pulley to
prevent the wire from being loosened.
e-STUDIO520/600/720/850 SCANNING SECTION
Carriage-1
6 - 22
Fig.6-35
( A )
( B )
( A )
Carriage-1
Fig.6-36
Wire holder jig
Fig.6-37
March 2005 © TOSHIBA TEC