Toshiba e-STUDIO520 Service Manual page 242

Notes:
1. When replacing the recovery blade, be
sure to separate it completely because it
is attached with the two-sided adhesive
tape.
2. Attach the recovery blade by pushing its
lower edge against the step of the cleaner
frame. (A in the figure on the right)
[E] Cleaning brush
(1) Take off the drum.
( P.11-7 "[B] Drum thermistor (THM5) and
Drum")
(2) Pull out the shaft held on the rear side to take
out the cleaning brush.
[F] Image quality sensor (S14)
(1) Take off the cleaner unit.
( P.11-7 "[A] Cleaner unit")
(2) Disconnect 1 connector and remove 2
screws to take off the image quality sensor.
e-STUDIO520/600/720/850 DRUM/CLEANER UNIT
Recovery blade
Cleaner flame
Cleaning brush
Image quality sensor
11 - 10
Drum
( A )
Fig.11-15
Holding shaft
Fig.11-16
Fig.11-17
March 2005 © TOSHIBA TEC