Toshiba e-STUDIO520 Service Manual page 308

(4) Disconnect 3 connectors and remove 6
screws to take off the IH board.
[B] Fuser unit
(1) Remove 2 screws and open the IH cover-1
carefully to the front side.
(2) Remove 2 screws to take off a knob cover.
(3) Remove 4 screws and then release 4 power
supply harnesses of the IH coil.
(4) Disconnect 4 connectors.
(5) Remove 2 screws and open the IH cover-2 to
the front side.
e-STUDIO520/600/720/850 FUSER UNIT
Heater control PC board
Screw
Connector
IH cover-2
Connector
14 - 18
Screw
Connector
( Yellow )
Connector
( White )
Screw
Fig.14-13
Knob cover
Fig.14-14
Screw
Connector
Fig.14-15
March 2005 © TOSHIBA TEC
Screw
Screw
Screw
Screw