Toshiba e-STUDIO520 Service Manual page 284

(4) Turn the driving roller to the direction of the
arrow.
(5) Pull out the transfer belt.
Notes:
1. Install the transfer belt in the middle so
that it does not move to one side.
2. Do not touch the surface of the belt.
3. Fix the link plate securely by pressing the
rear and front side of the plate to the
direction of the arrow.
[C] Cleaning brush
(1) Take off the transfer unit.
( P.13-6 "[A] Transfer unit")
(2) Take off the transfer belt unit.
( P.13-7 "[B] Transfer belt")
(3) Remove 1 clip and then 3 gears.
Notes:
1. There are latches on gear "a" and "c".
Remove gear "a", "b" and then "c".
2. When installing the gear, be sure that the
latch is securely inserted into the groove
of the shaft.
(4) Remove 1 screw and then the plate spring.
(5) Slide the transport guide to the rear side to
pull it out upward.
(6) Remove 1 clip and then the bushing.
(7) Push the brush to the rear side, take off the
shaft on the front side and then pull it out to
the upper front side.
Note:
Do not touch the surface of the brush.
e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT
Screw
Plate spring
c
a
13 - 8
Transfer belt
Fig.13-9
Transport guide
b
Fig.13-10
Cleaning brush
Bush
Fig.13-11
March 2005 © TOSHIBA TEC
Clip