Toshiba e-STUDIO520 Service Manual page 204

(3) Remove 2 screws to take off the solenoid.
Notes:
1. When installing the solenoid, install it for
the edge of the solenoid to get in phase
with the edges of the plate.
2. When installing the solenoid, fix it at the
position where the bosses of two gears
are put each other.
3. Put on the spring in the place shown by
the figure.
[C-4] Separation roller
(1) Remove 4 screws to take off the paper
guide.
e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM
Bypass pickup
solenoid
Screw
9 - 30
05/07
Screw
Fig.9-41
Marking
Spring
Fig.9-42
Paper guide Screw
Screw
Fig.9-43
March 2005 © TOSHIBA TEC