Toshiba e-STUDIO520 Service Manual page 333

[E] Exit cover switch [SW5]
(1) Take off the left lower cover (= exit cover)
( P.2-46 "[J] Left lower cover (Exit cover)").
(2) Open the exit/reverse unit. Then disconnect
the connector and release the latch to take
off the exit cover switch.
[F] Gate solenoid [SOL2]
(1) Take off the left lower cover (= exit cover)
( P.2-46 "[J] Left lower cover (Exit cover)").
(2) Open the exit/reverse unit. Then disconnect
1 connector, release the clamp and remove 3
screws to take off the gate solenoid.
Note:
The solenoid is normally screwed at the posi-
tion A shown in the figure at right. However,
the position of the solenoid can be adjusted
by moving this screw to the position B when
the flap valve of the solenoid is not pulled
enough.
March 2005 © TOSHIBA TEC
Fig.15-14
Gate solenoid
Fig.15-15
Fig.15-16
e-STUDIO520/600/720/850 EXIT/REVERSE SECTION
15 - 13
Exit cover switch
B
A
15