Toshiba e-STUDIO520 Service Manual page 197

[A-4] Transport sensor (S33/S39/S45/S51)
(1) Remove 1 screw to take off the transport
sensor with its bracket.
(2) Disconnect 1 connector to take off the trans-
port sensor.
Note:
When installing the sensor, make sure the
sensor arm moves properly.
[A-5] Feed clutch (CLT6/CLT8/CLT10/CLT12) and Transport clutch (CLT5/CLT7/CLT9/CLT11)
(1) Release the harness from the harness
clamp. Then remove 1 screw to take off the
clutch cover.
(2) Disconnect each connector and remove 1 E-
ring to take off the feed clutch and transport
clutch.
Notes:
1. When installing the clutch, do not insert
the wrong harness.
2. Fit in the protrusion of the clutch to the
stopper.
3. When fixing the clutch with the E-ring, be
sure that the one side of the E-ring latch
does not overlap the flat part of the shaft.
March 2005 © TOSHIBA TEC
Fig.9-21
Clutch cover
Fig.9-22
Harness: Black
Transport clutch
Fig.9-23
e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM
9 - 23
Transport sensor
Harness: Purple
Feed clutch
9