Toshiba e-STUDIO520 Service Manual page 428

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO520:

Table of Contents

Large original exit motor (M39)

Take off the ADF board with its bracket

P.16-87 "[C] RADF control PC board

(ADF board)").

Disconnect 1 connector and remove 1

Loosen 2 screws to release the tension of

the belt. Then tighten these screws tempo-

Remove 2 screws to take off the large origi-

nal exit motor with its bracket.

Remove 2 screws to take off the large origi-

nal exit motor from the bracket.

Hang the timing belt over the pulley of the

large original exit motor. Then fix the bracket

with 2 screws.

Attach 1 spring.

Loosen the screws fixing the bracket tempo-

rarily. Then tighten these screws so that the

timing belt will be tightened.

Be sure that the timing belt has been tight-

ened completely.

e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)

Tension spring

Large original exit motor

E-studio600 E-studio720 E-studio850