Toshiba e-STUDIO520 Service Manual page 275

[N] Toner filter unit / Developer unit fan (M31)
(1) Take off the right rear cover.
( P.2-45 "[H] Right rear cover")
(2) Pull out the toner filter.
(3) Remove 2 screws to pull out the filter duct.
(4) Disconnect 1 connector of the fan.
(5) Remove 3 screws to take off the fan.
[O] Toner bag full detection sensor (S11)
(1) Take off the SYS board case.
( P.2-48 "[A] System control PC board
(SYS board) / SYS board case")
(2) Disconnect 1 connector and remove 1 screw
to take off the toner bag full detection sensor.
March 2005 © TOSHIBA TEC
Toner filter
Filter duct
Fig.12-51
Developer unit fan
Fig.12-52
Toner bag full detection sensor
Fig.12-53
e-STUDIO520/600/720/850 DEVELOPER UNIT
12 - 29
12