Toshiba e-STUDIO520 Service Manual page 367

12)Start of 2nd original back side feeding
Same operation as 16.5.2. 7)
13)Start of 2nd original back side scanning
Same operation as 16.5.2. 8)
14)Idle reversing and discharging of 2nd original
Both the large original exit and read motors (M39, M36) start to rotate forward. When the leading
edge of the original has reached the read sensor (S69) then been transported a specified distance
by the read motor (M36), the large original exit roller release solenoid (SOL6) turns ON. The large
original exit motor (M39) stops when the large original exit roller release solenoid (SOL6) has turned
ON.
When the leading edge of the original has been transported to the large original exit side and
reached the 3rd roller and, the large original exit motor (M39) starts to rotate in reverse.
The large original exit motor (M39) starts to slow down when the trailing edge of the original has
passed the 4th roller and proceeded a specified distance. The read motor (M36) stops rotating with-
out a next original.
The large original exit motor (M36) stops rotating when the trailing edge of the original has been
detected by the large original exit sensor (S68) and proceeded a specified distance. The large origi-
nal exit solenoid (SOL5) turns OFF and the operation ends when the original has been discharged.
March 2005 © TOSHIBA TEC
Fig.16-57
Fig.16-58
e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
16 - 31
16