Toshiba e-STUDIO520 Service Manual page 346
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO520:
- Service handbook (650 pages) ,
- User functions manual (202 pages) ,
- Network administration manual (124 pages)
Table of Contents
Advertisement
6) Start of 2nd original scanning
Scanning begins after receiving the original transport signal from the engine. At the same time, the
original stop signal is reset. Then the read motor (M36) starts to rotate forward and the large original
exit motor (M39) starts to rotate in reverse.
The SCN-SCR turns ON when the leading edge of the original has reached the scanning section.
When the trailing edge of 1st original has proceeded a specified distance after passing the 3rd roller,
the large original exit motor (M39) starts to accelerate.
When the leading edge of the original has been transported to the intermediate transport section
and come to a specified distance before the intermediate transport roller, The large original exit
motor (M39) starts to rotate in reverse.
The SCN-SCR turns OFF when the leading edge of the original has reached the scanning section.
When the trailing edge of the original has proceeded a specified distance after passing the 3rd roller,
the large original exit motor (M39) starts to accelerate.
e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
Fig.16-16
Fig.16-17
Fig.16-18
16 - 10
March 2005 © TOSHIBA TEC
Advertisement
Table of Contents
