Toshiba e-STUDIO520 Service Manual page 274

[L] Developer unit motor (M10)
(1) Take off the rear cover.
( P.2-47 "[L] Rear cover")
(2) Take off the SYS board case.
( P.2-48 "[A] System control PC board
(SYS board) / SYS board case")
(3) Remove 3 screws to take off the flywheel.
(4) Disconnect 1 connector, remove 3 screws
and then take off the developer unit motor
with bracket.
(5) Remove 2 screws to take off the motor from
the bracket.
[M] Developer unit detection switch (SW3)
(1) Take off the cleaner unit.
( P.11-7 "[A] Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw and
then take off the sensor bracket.
(3) Disconnect 2 connectors, remove 1 screw
and then take off the developer unit detection
switch.
e-STUDIO520/600/720/850 DEVELOPER UNIT
Developer unit motor
Screw
Sensor braket
Screw
Developer unit detection switch
12 - 28
Connector
Screw
Screw
Fig.12-48
Screw
Fig.12-49
Connector
Fig.12-50
March 2005 © TOSHIBA TEC