Toshiba e-STUDIO520 Service Manual page 215

[J-5] End fence home position sensor (S73) / Standby side empty sensor (S74) / End fence stop
position sensor (S75)
(1) Remove 1 screw and take off the plate cover.
(2) Disconnect the connector for each sensor,
and take off the sensor.
[J-6] Tandem LCF tray-up motor (M41)
(1) Take off the switching regulator.
( P.2-51 "[E] Switching regulator (PS)")
(2) Disconnect 1 connector, remove 3 screws
and take off the Tandem LCF tray-up motor.
March 2005 © TOSHIBA TEC
End fence
Fig.9-74
End fence
stop position sensor
Standby side empty sensor
Fig.9-75
Tandem LCF tray-up motor
Fig.9-76
e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM
9 - 41
Plate cover
End fence
home position sensor
Screw
Screw
9