Toshiba e-STUDIO520 Service Manual page 109

No. Message
18 READY
(FINISHER FULL)
19 READY
(HOLE PUNCH DUST BIN
IS FULL)
20 READY
(SADDLE STITCH TRAY
FULL)
21 READY
(CHANGE DRAWER TO
CORRECT PAPER SIZE)
22 Ready for bypass feeding
23 COPYING
24 Auto Start
25 Place Doc. Feeder in the
down position
26 Place originals in the docu-
ment feeder
27 Change direction of original Displayed when the direction of origi-
28 PRESS [BASIC] and select
normal paper size
29 %d originals are scanned
Start copy job from next
page
30 Add paper
31 Cannot duplex this size
32 Cannot use this media type Displayed when the paper size which
33 Set standard size
34 Cannot staple this paper
type
35 Cannot duplex copy
36 Cannot use transparency
film
37 Copy size: A4/LT only
March 2005 © TOSHIBA TEC
State of equipment
Finisher is full of paper
• Scanning is enabled
Punching dust box is full
• Scanning is enabled
Saddle stitcher tray is full of paper
• Scanning is enabled
Incorrect paper size setting
Paper is set on the bypass tray
At the copying state
Auto Start is set during printing
RADF is open when original is placed
on RADF
Displayed when the conditions are
set and [START] button is pressed
with no original placed
nal placed is different from the setting
Displays the warning that the copy is
not enabled when any drawer but
bypass feed is selected at Cover
Sheet Copying Mode or Sheet Inser-
tion Mode
Paper jam occurred during copying
(RADF scanning)
Displayed when the paper in
selected drawer is running out
Displayed when the paper size which
is not specified for duplex copying is
set
is not specified for the functions such
as stapling or hole punching is set
Displayed when the paper size which
is not acceptable is set (depends on
the setting)
Displayed when the paper type which
can not be stapled is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Displayed when the paper type which
can not be duplexed is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Displayed when the paper type which
can not be punched is set at Cover
Sheet Copying Mode/Sheet Inser-
tion Mode
Displayed when the paper size which
is not specified for "Book-type duplex
copying" or "Dual-page" is set
5 - 5
Note
Resumes printing by removing paper
from the finisher
Resumes printing by removing
punching dust from the dust box
Cleared by pressing [FUNCTION
CLEAR] button or [STOP] button
Cleared by closing RADF
Cleared by setting the original
Re-set the paper size
Re-set the paper type
Re-set the paper type
Re-set the paper type
e-STUDIO520/600/720/850 CONTROL PANEL
5