Toshiba e-STUDIO520 Service Manual page 205

(2) Remove 1 clip and take off the separation
roller by lifting the shaft.
[C-5] Bypass paper size detection sensor (S28)
(1) Disconnect 1 connector and release it from
the clamp.
(2) Remove 2 brackets on both sides of the tray
and 2 screws each to take off the bypass
tray.
(3) Remove 3 screws and release 4 latches to
take off the bypass tray upper cover.
March 2005 © TOSHIBA TEC
Separation roller
Fig.9-44
Screw
Fixing bracket
Fig.9-45
Bypass tray upper cover
Latch
Screw
Fig.9-46
e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM
9 - 31
Clip
Connector
Screw
Latch
9