Toshiba e-STUDIO520 Service Manual page 145

[H] Carriage-1
(1) Take off the lens cover
( P.6-16 "[B] Lens cover").
(2) Move the carriage-1 to the left side and
remove 2 screws.
(3) Move the carriage-1 to the position where
the side of the frame is cut out, and then pull
its bracket downward.
(4) Disconnect 1 connector of the SLG board.
Then remove 3 stickers and release the har-
ness from 2 clamps.
March 2005 © TOSHIBA TEC
Fig.6-32
Carriage-1
Fig.6-33
Fig.6-34
e-STUDIO520/600/720/850 SCANNING SECTION
6 - 21
Bracket
Sticker
Clamp
6