Toshiba e-STUDIO520 Service Manual page 200

(4) Disconnect 2 board connectors and release
4 lock supports to take off the board.
[B-2] Transport motor (M17)
(1) Disconnect 1 connector.
(2) Remove 2 screws to take off the motor.
[B-3] Transport roller
(1) Remove 1 E-ring to pull out the bearing from
the shaft.
(2) Remove the pin of the pulley by moving the
shaft toward the motor. Then remove the pul-
ley and bearing to take off the transport roller
with its shaft.
e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM
Motor driving PC board
Belt
Pin
Pulley
Bearing
9 - 26
Fig.9-30
Transport motor
Fig.9-31
Bearing
Fig.9-32
March 2005 © TOSHIBA TEC