Toshiba e-STUDIO520 Service Manual page 122

(5) Remove 3 screws. Then open the RADF and
take off the control panel unit.
Note:
When assembling the unit, be sure that the
harness is not caught.
[B] Display PC board (DSP)
(1) Take off the control panel unit
( P.5-17 "[A] Control panel unit").
(2) Disconnect 6 connectors and release 2 flat
harnesses.
(3) Remove 4 screws and take off the DSP
board.
Note:
When installing the board, be sure to fix the
shielding wire of the LCD.
[C] LCD inverter board (NV-LCD]
(1) Take off the control panel unit
( P.5-17 "[A] Control panel unit").
(2) Take off the DSP board
( P.5-18 "[B] Display PC board (DSP)").
(3) Remove 8 screws and take off the base stay.
e-STUDIO520/600/720/850 CONTROL PANEL
Control panel unit
DSP board
Base stay
5 - 18
Fig.5-13
Shielding wire
Fig.5-14
Fig.5-15
March 2005 © TOSHIBA TEC