Toshiba e-STUDIO520 Service Manual page 430
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO520:
- Service handbook (650 pages) ,
- User functions manual (202 pages) ,
- Network administration manual (124 pages)
Table of Contents
Advertisement
[G] Sensor / Switch
[G-1]
Lifting tray upper limit detection sensor (S59) / Original empty sensor (S60) / Jam access cover
sensor (S61)
(1)
Open the jam access cover. Then remove 2
screws to take off the upper guide cover.
(2)
Disconnect 1 connector for each to take off
the lifting tray upper limit detection sensor,
original empty sensor and jam access cover
sensor.
Note:
Lift up the pickup unit before taking off the
lifting tray upper limit detection sensor.
[G-2]
Lifting tray lower limit detection sensor (S62)
(1)
Take off the upper guide unit
(
P.16-88 "[D-2] Separation roller").
(2)
Remove 2 screws to take off the upper guide
stay.
(3)
Open the reverse guide. Then release the
inserted portion on the front side of the guide
to take it out to the front side.
(4)
Remove 4 screws to take off the lower guide.
Note:
2 screws on the front side are stepped
screws.
e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
Original empty sensor
Lifting tray upper limit detection sensor
Screw
Inserted portion
Stepped screw
16 - 94
Jam access cover sensor
Fig.16-131
Upper guide stay
Fig.16-132
Reverse guide
Lower guide
Fig.16-133
March 2005 © TOSHIBA TEC
Screw
Screw
Advertisement
Table of Contents
