Toshiba e-STUDIO520 Service Manual page 287

(8) Shift A or B from your left to your right hand
and then hold C in your left hand.
(9) Take off the transfer/transport unit from the
slide rail by lifting it up.
Notes:
1. When lifting up the transfer/transport unit,
do not hold D (Transport guide) because
it may cause damage to the transport
guide.
2. When installing, follow the procedure
below.
(10) Pull out the slide rail on the left side com-
pletely.
(11) Hook the transfer/transport unit on the slide
rail on the left side properly.
(12) Extend the slide rail on the right side. Make
sure to extend the leading edge of the slide
rail completely.
(13) Hook the transfer/transport unit on the slide
rail on the right side.
(14) Fix the transfer/transport unit with 2 stepped
screws.
(15) Assemble it in the reverse order of the disas-
sembling procedure.
[F] Horizontal transport sensor-1, -2 and -3 (S19, S20, S21)
(1) Take off the transfer unit.
( P.13-6 "[A] Transfer unit")
(2) Take off the fuser unit.
( P.14-18 "[B] Fuser unit")
(3) Remove 1 screw to take off each sensor with
its bracket.
(4) Disconnect 1 connector and release the latch
to take off each sensor.
Note:
The horizontal transport sensor-3 (S21) can
be replaced without the transport unit being
taken off.
March 2005 © TOSHIBA TEC
C
Fig.13-18
Horizontal transport
sensor-1
Screw
Horizontal transport
sensor-2
Fig.13-19
e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT
13 - 11
D
Horizontal transport
sensor-3
Screw
13