Servo Cable; Speed Control Servo; Speed Control Switches; Stop Lamp Switch - Jeep 1997 Grand Cherokee Service Manual

SERVO MOUNTING NUTS (2)

SERVO CABLE

ZG
REMOVAL AND INSTALLATION (Continued)
(7) Remove clip attaching cable to servo.
(8) Remove servo from mounting bracket.
Fig. 4 Speed Control Servo
INSTALLATION
(1) Position servo to mounting bracket.
(2) Block throttle to full open position to align hole
in cable connector with hole in servo pin. Install
cable-to-servo retaining clip.
(3) Install servo mounting nuts and tighten to 8.5
N·m (75 in. lbs.).
(4) Connect vacuum hose at servo.
(5) Connect electrical connector at servo.
(6) Remove throttle block.
(7) Connect negative battery cable to battery.

SPEED CONTROL SWITCHES

REMOVAL
WARNING: BEFORE BEGINNING ANY AIRBAG
SYSTEM COMPONENT REMOVAL OR INSTALLA-
TION, REMOVE AND ISOLATE THE NEGATIVE (-)
CABLE FROM THE BATTERY. THIS IS THE ONLY
SURE WAY TO DISABLE THE AIRBAG SYSTEM.
THEN WAIT TWO MINUTES FOR SYSTEM CAPACI-
TOR TO DISCHARGE BEFORE FURTHER SYSTEM
SERVICE. FAILURE TO DO THIS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE INJURY.
(1) Disconnect and isolate negative battery cable.
(2) Remove airbag module. Refer to Group 8M,
Passive Restraint Systems for procedures.
(3) Remove electrical connector at switch.
(4) Remove switch-to-steering
screw (Fig. 5).
(5) Remove switch.
INSTALLATION
sive Restraint Systems for procedures.

STOP LAMP SWITCH

removal/installation and adjustment procedures.
SERVO CABLE
REMOVAL
remove speed control cable connector at throttle body
bellcrank pin by pushing connector off the bellcrank
towards the drivers side of vehicle (Fig. 6). DO NOT
try to pull connector off perpendicular to the
bellcrank pin. Connector will be broken.
remove speed control cable connector at throttle body
bellcrank by pushing connector rearward off the
bellcrank pin (Fig. 7). DO NOT try to pull connec-
tor off perpendicular to the bellcrank pin. Con-
nector will be broken.
top of valve cover.
wheel mounting
at throttle body mounting bracket (locking plate) and
push out of bracket.
MOUNTINGSCREW
VEHICLE SPEED CONTROL SYSTEM
Fig. 5 Speed Control Switches
(1) Install switch and mounting screw.
(2) Tighten screw to 1.5 N·m (15 in. lbs.) torque.
(3) Install electrical connector to switch.
(4) Install airbag module. Refer to Group 8M, Pas-
(5) Connect negative battery cable.
Refer to Stop Lamp Switch in Group 5, Brakes for
(1) Disconnect negative battery cable at battery.
(2) 4.0L Engine: Using finger pressure only,
(3) 5.2L/5.9L Engines: Using finger pressure only,
(4) 4.0L Engine: Remove cable from cable guide at
(5) Squeeze 2 tabs on sides of speed control cable
SPEED CONTROL SWITCHES
8H - 7