Jeep 1997 Grand Cherokee Service Manual page 262

COUS THERMAL THREADED FAN BLADE ASSEM- NUT (4) FAN HUB-TO-PUMP PULLEY NUTS DRIVE (4) FAN BLADE-TO-VISCOUS VISCOUS FAN DRIVE VIS- FAN THREADED (WATER PUMP HUB) BLY P ULLEYBOLTS DRIVE BOLTS
7 - 34 COOLING SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 48 Fan Mounting Nuts—4.0L 6-Cyl.Engine
Fig. 49 Fan Blade and Viscous Fan Drive—5.2/5.9LV-
8 Engines
from the radiator. Refer to Group 21 for transmission
cooling line removal and installation.
(11) The radiator upper crossmember (Fig. 51) can
be adjusted left or right through the use of slotted
holes. Before removal, mark the original position of
the crossmember.
(12) Eight clips are used to retain a rubber seal
(Fig. 51) to the body and upper radiator crossmem-
ber. Gently pry up the outboard clips (two per side)
SHAFT (4) FAB HUB-TO-PUMP PULLEY FAN BLADE WATER PUMP PUL- CRANKSHAFT WATER PUMP WATER PUMP LEY STUDS
WATER
PUMP PUL-
LEY
BYPASS PULLEY HOSE OUTER CLIPS HIDDEN BOLT HOOD UPPER CROSS- RADIATOR CONDENSER BRACKET MEMBER LATCH BOLT FAN SHROUD MOUNTING NUTS
Fig. 50 Radiator and A/C Condenser Mounting
Fig. 51 Radiator Upper Crossmember—Typical
until rubber seal can be removed. Do not remove the
clips entirely. Fold back the seal on both sides for
access to (the hidden) grille opening reinforcement
mounting bolts (Fig. 51). Remove these two bolts.
(13) Remove the grill. Refer to group 23, Body.
(14) Remove the upper brace bolt from each of the
two radiator braces (Fig. 50).
(15) Remove
mounting nuts (Fig. 51).
(16) Working through grill opening, remove the
lower bracket bolt securing lower part of hood latch
RUBBER SEAL OVERFLOW HOSE BRACKET BOLT LOWER ALIGNMENT CLIP DOWELS HIDDEN BOLT DIATOR CROSSMEMBER-TO-RA-
HOOD LATCH
the two crossmember-to-radiator
UPPER BRACE BOLTS CONDENSER BOLT OUTER CLIPS MOUNTING NUTS
ZG