Jeep 1997 Grand Cherokee Service Manual page 51

ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 8 Track Bar
HUB BEARING
REMOVAL
(1) Raise and support the vehicle.
(2) Remove the wheel and tire assembly.
(3) Remove the brake caliper, rotor and ABS wheel
speed sensor, refer to Group 5 Brakes.
(4) Remove the cotter pin, nut retainer and axle
hub nut (Fig. 9).
(5) Remove the hub mounting bolts and remove
hub bearing from the steering knuckle and axle
shaft.
INSTALLATION
(1) Install the hub bearing and brake dust shield
to the knuckle.
(2) Install the hub to knuckle bolts and tighten to
102 N·m (75 ft. lbs.).
(3) Install the hub washer and nut. Tighten the
hub nut to 237 N·m (175 ft. lbs.). Install the nut
retainer and a new cotter pin.
(4) Install the brake rotor, caliper and ABS wheel
speed sensor, refer to Group 5 Brakes.
(5) Install the wheel and tire assembly.
(6) Remove support and lower the vehicle.
WHEEL MOUNTING STUDS
REMOVAL
(1) Raise and support vehicle.
(2) Remove wheel and tire assembly.
(3) Remove brake caliper and rotor, refer to Group
5 Brakes for procedure.
Fig. 9 Hub Bearing & Knuckle
SUSPENSION 2 - 11