Service Procedures; Remote Keyless Entry Transmitter; Battery Replacement; Remote Keyless Entry Transmitter Programming - Jeep 1997 Grand Cherokee Service Manual

8P - 6 POWER LOCK SYSTEMS
DIAGNOSIS AND TESTING (Continued)
be continuity. If OK, go to Step 7. If not OK, replace
the faulty push button switch.
(7) Unplug the liftglass release solenoid wire har-
ness connector. Check for continuity between the
ground circuit cavity of the wire harness connector
and a good ground. There should be continuity. If
OK, go to Step 8. If not OK, repair the open circuit
as required.
(8) With the liftgate latch unlocked and the lift-
glass push button switch depressed, check for battery
voltage at the liftglass push button output circuit
cavity of the liftglass release solenoid wire harness
connector. If OK, replace the faulty solenoid. If not
OK, repair the open circuit as required.

SERVICE PROCEDURES

REMOTE KEYLESS ENTRY TRANSMITTER

BATTERY REPLACEMENT

To replace the Remote Keyless Entry (RKE) trans-
mitter batteries, separate the transmitter case halves
at the center seam by prying gently with a trim
stick, or other suitable wide, flat-bladed tool. The
case snaps open and shut.
Replace the two batteries with new Duracell
DL2016, or their equivalent. Be certain that the bat-
teries are installed with their polarity correctly ori-
ented. Then, align the two transmitter case halves
with each other, and squeeze them firmly together
until they snap back into place.
REMOTE KEYLESS ENTRY TRANSMITTER
PROGRAMMING
To program the Remote Keyless Entry (RKE)
transmitter access codes into the RKE receiver in the
passenger door module requires the use of a DRB
scan tool. Refer to the proper Body Diagnostic Proce-
dures manual for more information.

REMOVAL AND INSTALLATION

DOOR MODULE

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the bezel near the inside door latch
release handle by inserting a straight-bladed screw-
driver in the notched end and prying gently upwards.
(3) Remove the door trim panel mounting screw
located in the bezel opening near the inside door
latch release handle (Fig. 1).
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Remove the trim cap and screw at the upper
front corner of the trim panel.
U-NUT
FRONT DOOR
U-NUT
MEMORY SWITCH POWER MOUNTING SCREWS CONNECTOR CONNECTOR MIRROR
Fig. 1 Front Door Trim Panel Remove/Install
(6) Remove the screw located above the front door
speaker grille.
(7) Using a wide flat-bladed tool such as a trim
stick, pry the trim panel away from the door around
the perimeter and remove the trim panel.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(8) Unplug the wire harness connectors from the
door module and the door courtesy lamp, if equipped.
(9) Remove the five screws that secure the door
module to the door trim panel (Fig. 2).
Fig. 2 Door Module Remove/Install
(10) Remove the door module from the trim panel.
(11) Reverse the removal procedures to install.
DOOR MODULE CON- NECTOR 12–WAY
ZG