8E - 24
INSTRUMENT PANEL SYSTEMS
REMOVAL AND INSTALLATION (Continued)
INSTRUMENT CLUSTER
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT
SYSTEMS BEFORE ATTEMPTING STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COM-
PONENT DIAGNOSIS OR SERVICE. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT
IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
(1) Remove the cluster bezel as described in this
group.
(2) Remove the two screws that secure each end of
the instrument cluster to the instrument panel.
(3) Pull the instrument cluster rearward and
remove it from the vehicle.
(4) Reverse the removal procedures to install.
CLUSTER LENS, HOOD, AND MASK
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT
SYSTEMS BEFORE ATTEMPTING STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COM-
PONENT DIAGNOSIS OR SERVICE. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT
IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
(1) Remove the cluster bezel as described in this
group.
this group.
it off of the switch stem (Fig. 6).
lens to the cluster hood and gently pull the lens
away from the hood.
hood to the cluster circuit and gauge housing and
gently pull the hood away from the housing.
locating pins on the front of the cluster circuit and
gauge housing.
GAUGE
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT
SYSTEMS BEFORE ATTEMPTING STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COM-
PONENT DIAGNOSIS OR SERVICE. FAILURE TO
TAKE THE PROPER PRECAUTIONS COULD RESULT
IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
described in this group.
from the rear of the cluster circuit and gauge housing
(Fig. 7).
Fig. 6 Instrument Cluster Components
(2) Remove the instrument cluster as described in
(3) Remove the trip odometer reset knob by pulling
(4) Depress the snap clips that secure the cluster
(5) Depress the snap clips that secure the cluster
(6) Gently lift the gauge mask away from the
(7) Reverse the removal procedures to install.
(1) Remove the cluster lens, hood, and mask as
(2) Remove the screws that secure the gauge(s)
ZG