Jeep 1997 Grand Cherokee Service Manual page 328

REAR BOLT SOLENOID FEED WIRE STARTER STARTER MOTOR
8B - 10 STARTING SYSTEMS
REMOVAL AND INSTALLATION (Continued)
• Front starter support bracket bolt - 47 N·m (35
ft. lbs.).
4.0L ENGINE
(1) Disconnect and isolate the battery negative
cable.
(2) Raise and support the vehicle.
(3) Remove the battery cable and wire harness
connection from the starter solenoid (Fig. 13).
Fig. 13 Starter Wire Harness Remove/Install- Typical
(4) Remove the front starter mounting bolt and the
automatic transmission oil cooler line bracket (Fig.
14).
Fig. 14 Starter Remove/Install - 4.0L Engine
(5) Remove the rear starter mounting bolt and
lower the starter.
SOLENOID FWD BATTERY BRACKET
REMOVE
NUTS (2)
FRONT BOLT WIRE FEED
(6) Reverse the removal procedures to install.
Tighten the starter hardware as follows:
• Upper mounting bolt - 55 N·m (40 ft. lbs.)
• Lower mounting bolt - 41 N·m (30 ft. lbs.)
• Battery cable terminal nut - 10 N·m (90 in. lbs.)
• Solenoid wire harness terminal nut - 6 N·m (55
in. lbs.).
5.2L AND 5.9L ENGINE
(1) Disconnect and isolate the battery negative
cable.
(2) Raise and support the vehicle.
(3) Remove the battery cable and wire harness
connection from the starter solenoid (Fig. 13).
(4) Remove the lower starter mounting bolt and
the exhaust brace (Fig. 15).
Fig. 15 Starter Remove/Install - 5.2L and5.9L Engine
(5) Remove the upper starter mounting nut, lock
washer, and automatic transmission oil cooler line
bracket.
(6) Move the starter towards the front of the vehi-
cle until the starter gear housing nose clears the bell-
housing. Then tilt the starter nose downwards past
the exhaust pipe.
(7) Reverse the removal procedures to install.
Tighten the starter hardware as follows:
• Lower mounting bolt - 68 N·m (50 ft. lbs.)
• Upper mounting nut - 68 N·m (50 ft. lbs.)
• Battery cable terminal nut - 10 N·m (90 in. lbs.)
• Solenoid wire harness terminal nut - 6 N·m (55
in. lbs.).
FWD STARTER BRACE STUD BRACKET LOCKWASHER LOWER BOLT UPPER NUT
ZG