Jeep 1997 Grand Cherokee Service Manual page 490

INBOARD SWITCH POD MOUNT-
8K - 14 WIPER AND WASHER SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(15) Unplug the wire harness connector from the
multi-function switch.
(16) Reverse the removal procedures to install.
Tighten the fasteners as follows:
• Multi-function switch wire harness connector
screw - 2 N·m (17 in. lbs.)
• Multi-function switch retaining screws - 2 N·m
(17 in. lbs.)
• Steering column upper bracket nuts - 12 N·m
(110 in. lbs.).
REAR
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick or another suitable wide
flat-bladed tool, pry gently around the edges of the
inboard switch pod bezel and remove the bezel.
(3) Remove the three screws that secure the
inboard switch pod to the instrument panel (Fig. 15).
Fig. 15 Inboard Switch Pod Remove/Install
(4) Pull the inboard switch pod out from the
instrument panel far enough to unplug the wire har-
ness connectors.
ING SCREWS
GROUP 8M -
STEERING COLUMN,
(5) Remove the inboard switch pod from the
instrument panel.
(6) Reverse the removal procedures to install.
WASHER PUMP AND RESERVOIR
MOUNTING BOLT RESERVOIR FENDER
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the three screws that secure the
washer reservoir to the inner fender shield (Fig. 16).
PASSIVE
OR
Fig. 16 Washer Reservoir Remove/Install
(3) Lift the reservoir far enough to access the
washer pump wire harness connectors and hoses.
(4) Remove the washer hoses from the washer
pumps and drain the washer fluid from the reservoir
into a clean container for reuse.
(5) Unplug the wire harness connectors from the
washer pumps and the washer fluid level sensor, if
the vehicle is so equipped.
(6) Use a deep socket and extension inserted
through the reservoir filler neck to remove the
washer pump filter/nuts from the inside of the reser-
voir.
(7) Remove the washer pumps from the reservoir.
(8) If the vehicle is so equipped, gently pry the
washer fluid level sensor away from the reservoir.
Care must be taken not to damage the reservoir.
(9) Remove the rubber grommet seals from the
reservoir and discard.
(10) Reverse the removal procedures to install.
Always use new rubber grommet seals on the
reservoir.
WINDSHIELD WASHER PUMP WASHER RESER- VOIR
ZG
RESERVOIR MOUNTING BOLT LIFTGATE WASHER PUMP