Jeep 1997 Grand Cherokee Service Manual page 45

ZG
SERVICE PROCEDURES (Continued)
• Vehicles with 2.5L engine: 27 N·m (20 ft. lbs.)
• Vehicles with 4.0L engine: 27 N·m (20 ft. lbs.)
• Vehicles with 5.2L engine: 49 N·m (36 ft. lbs.)
NOTE: Make sure the toe setting does not change
during clamp tightening.
Fig. 5 Steering Linkage (RHD)
(4) Adjust the right wheel toe position with the tie
rod. Turn the sleeve until the right wheel is at the
same TOE-IN position as the left wheel. Position the
clamp bolt to it's original position and tighten to:
• Vehicles with 2.5L engine: 27 N·m (20 ft. lbs.)
• Vehicles with 4.0L engine: 27 N·m (20 ft. lbs.)
• Vehicles with 5.2L engine: 49 N·m (36 ft. lbs.)
NOTE: Make sure the toe setting does not change
during clamp tightening.
(5) Verify the toe setting.
SPECIFICATIONS
ALIGNMENT
FRONT WHEELS
ADJUSTMENT PREFERRED
CASTER
CAMBER
(not adjustable)
TOE-IN
(each wheel)
Toe Differential Left to Right .05°
REAR AXLE
ADJUSTMENT
THRUST ANGLE
(not adjustable)
TOTAL TOE-IN
(not adjustable )
SUSPENSION
RANGE
7° 6.5° to 7.5°
NA − 1.13° to +
0.13°
0.12° 0° to + 0.22°
SPECIFICATION
.25°
0.00 to + 0.5°
2 - 5