Jeep 1997 Grand Cherokee Service Manual page 393

ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 9 Outboard Switch Pod Remove/Install
(4) Remove the outboard switch pod from the
instrument panel.
(5) Reverse the removal procedures to install.
INBOARD SWITCH POD
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
OUTBOARD MOUNTING SCREWS SWITCH TURN CLUSTER
Fig. 8 Cluster Bulb Locations
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
POD SIGNAL INDICATOR LAMPS ILLUMINATION INDICATOR LAMPS LAMPS INBOARD SWITCH POD MOUNT-
INSTRUMENT PANEL SYSTEMS
(2) Remove the inboard switch pod bezel as
described in this group.
(3) Remove the two screws that secure the inboard
switch pod to the instrument panel (Fig. 10).
Fig. 10 Inboard Switch Pod Remove/Install
(4) Pull the inboard switch pod out from the
instrument panel far enough to unplug the wire har-
ness connectors.
(5) Remove the inboard switch pod from the
instrument panel.
OR
(6) Reverse the removal procedures to install.
ING SCREWS
8E - 27