Jeep 1997 Grand Cherokee Service Manual page 33

RIGHT AXLE HOUSING SHOWN SIDE CAM LOWER USPENSION
ZG
REMOVAL AND INSTALLATION (Continued)
Fig. 4 Upper & Lower Suspension Arms
(7) Tighten the frame bracket nut to 176 N·m (130
ft. lbs.).
(8) Check the alignment if new parts were
installed.
UPPER SUSPENSION ARM
REMOVAL
(1) Raise and support the vehicle.
(2) Remove the upper suspension arm nut and bolt
at the axle bracket (Fig. 4).
(3) Remove the nut and bolt at the frame rail and
remove the upper suspension arm.
INSTALLATION
(1) Position the upper suspension arm at the axle
and frame rail.
(2) Install the bolts and finger tighten the nuts.
(3) Remove the supports and lower the vehicle.
(4) Tighten the nut at the axle and frame bracket
to 75 N·m (55 ft. lbs.).
AXLE BUSHING
REMOVAL
(1) Remove the upper suspension arm from axle
(2) Position Receiver 7932-1 (J-35581-1) over the
bushing in the axle and install Bushing Removal/In-
staller (Fig. 5).
(3) Remove the bushing by tightening the Long
Nut.
NOTE: For two-wheel drive axles and right side on
Model 30 axle, do not remove Receiver 7932-1
(J-35581-1) at this time.
INSTALLATION
(1) Position new bushing, Receiver and Installer
on axle (Fig. 6).
ARM CAM BOLT BOLT SPECIAL (J-21474–18) TOOL7603 SPECIAL AXLE BRACKET (J-21474–18) TOOL 7603 SPECIAL (J-35581–1) TOOL 7932–1
Fig. 5 Bushing Removal
(2) Install the bushing by tightening the Long Nut.
Fig. 6 Bushing Installation
(3) Remove tools and install the upper suspension
arm.
STABILIZER BAR
REMOVAL
(1) Raise and support the vehicle.
SPECIAL (J-21474–19) TOOL 7604 AXLE BRACKET SPECIAL SPECIAL SPECIAL SPECIAL (J-35581–2) (J-21474–19) (J-35581–2) 7932–2 (J-35581–1) TOOL 7932–2 TOOL TOOL 7932–1 7604 TOOL
SUSPENSION 2 - 7