Jeep 1997 Grand Cherokee Service Manual page 221

BRACKET SCREW FWD SENSOR BOLT SWITCH PART NUMBER ACCELERATION SENSOR
ZG
REMOVAL AND INSTALLATION (Continued)
(3) Tilt rear seat assembly forward for access to
the switch.
(4) Disconnect switch harness (Fig. 12).
(5) Remove bolts attaching switch to bracket and
remove the switch.
INSTALLATION
CAUTION: The mercury switch inside the accelera-
tion switch, will only function properly if the locat-
ing arrow is pointing to the front of the vehicle (Fig.
13).
Fig. 13 Acceleration Switch
(1) Note position of locating arrow on switch. Posi-
tion switch so arrow faces forward.
(2) Position switch in mounting bracket.
BRACKET FLOORPAN SENSOR RISER ACCELERATION FRONT OF SWITCH FOR ARROW PROPER MOUNTING SENSOR
Fig. 12 Acceleration Switch Mounting
INDICATES FWD MOUNTING SCREWS CONNECTORS REAR SENSOR
(3) Install and tighten switch attaching bolts to
2-4 N·m (17-32 in. lbs.).
(4) Connect harness to switch. Be sure harness
connector is firmly seated.
(5) Move rear seat back to normal position.
(6) Connect battery negative cable.
DISASSEMBLY AND ASSEMBLY
HYDRAULIC CONTROL UNIT/CONTROLLER
ANTILOCK BRAKE
DISASSEMBLY
(1) Remove pump motor connector from the CAB.
(2) Remove CAB mounting screws from the HCU
(Fig. 14).
(3) Remove CAB from the HCU.
AND WIRES DRIVER CAB SIDE SILL
Fig. 14 CAB Mounting Screws
B-PILLAR
BRAKES 5 - 41