Jeep 1997 Grand Cherokee Service Manual page 450

POWER WINDOW CONNECTOR MOTOR
POWER WINDOW MOTOR FWD POWER WINDOW SWITCH
8F - 14 AUDIO SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(4) Remove the trim cap and screw near the rear
of the door armrest.
(5) Using a wide flat-bladed tool such as a trim
stick, gently pry the trim panel away from the door
around the perimeter to release the trim panel
retainers.
NOTE: To aid in the removal of the trim panel, start
at the bottom of the panel.
(6) Pull the trim panel away from the inner door
panel far enough to unplug the wire harness connec-
tor from the power window switch.
(7) Remove the three screws that secure the
speaker to the lower front corner of the inner door
panel (Fig. 14).
Fig. 14 Rear Door Speaker Remove/Install
(8) Pull the speaker away from the inner door
panel far enough to unplug the speaker wire harness
connector.
(9) Remove the speaker from the door.
(10) Reverse the removal procedures to install.
Tighten the hardware as follows:
• Speaker mounting screws - 1.1 N·m (10 in. lbs.)
• Trim panel mounting screws - 1.3 N·m (12 in.
lbs.).
SOUND BAR
TWEETER
(1) Remove the sound bar from the vehicle as
described in this group.
(2) Unplug the wire harness connector from the
tweeter.
CONNECTOR PLASTIC NUT LOCK MOTOR POWER SPEAKER SCREW
WOOFER
TWEETER
RETAINER
(3) From the inside of the sound bar, use a pair of
side cutters to cut and remove the push-nut type
retainer that secures the tweeter to the sound bar
(Fig. 15).
Fig. 15 Sound Bar Speakers Remove/Install
(4) Push the tweeter out of the mounting hole from
the inside of the sound bar.
(5) Reverse the removal procedures to install.
Always use a new push-nut retainer on the tweeter.
WOOFER
(1) Remove the sound bar from the vehicle as
described in this group.
(2) Unplug the wire harness connector from the
woofer.
(3) From the inside of the sound bar, straighten
the tabs that secure the speaker grille to the sound
bar (Fig. 15).
(4) From the outside of the sound bar, remove the
speaker grille.
(5) Carefully drill out the four rivets that secure
the woofer to the sound bar.
(6) Remove the woofer from the sound bar.
(7) Reverse the removal procedures to install. Use
new rivets installed from the inside of the sound bar
to secure the woofer.
SOUND BAR
(1) Disconnect and isolate the battery negative
cable.
(2) Gently pry at the edge of the five snap-fit
screw covers on the sound bar to remove them (Fig.
16).
ZG