Jeep 1997 Grand Cherokee Service Manual page 505

CHMSL FWD TRIM PANEL
ZG
REMOVAL AND INSTALLATION (Continued)
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
REMOVAL
(1) Raise liftgate.
(2) Remove upper liftgate trim panel.
(3) Remove CHMSL lamp mounting screws (Fig.
5).
(4) Remove CHMSL lamp.
(5) Turn bulb socket 1/4 turn counterclockwise.
(6) Separate socket from lamp.
Fig. 5 Center High Mounted Stop Lamp
INSTALLATION
(1) Position socket in lamp.
(2) Turn bulb socket 1/4 turn clockwise.
(3) Position CHMSL lamp in place and install
mounting screws.
(4) Install upper liftgate trim panel.
UNDERHOOD LAMP
REMOVAL
When equipped, the underhood lamp is installed on
the hood right, rear panel. The lamp is on when hood
is opened by way of liquid ON/OFF switch that is
integral with lamp base.
(1) Open hood.
(2) Remove screw attaching lamp support bracket
to hood (Fig. 6).
(3) Disengage connector for underhood lamp.
(4) Separate lamp from vehicle.
INSTALLATION
(1) Engage connector for underhood lamp.
(2) Position lamp on hood and install screw.
VISOR VANITY LAMP
REMOVAL
(1) Fold down sunvisor.
LIFTGATE HOOD LAMP ASSEMBLY HOOD BULB
(2) Starting at the base of the lamp assembly and
working right-to-left, use a small flat blade, carefully
pry lamp from visor.
(3) Disconnect visor lamp wire connector and
remove from vehicle.
INSTALLATION
(1) Position visor lamp at visor and connect visor
lamp wire connector.
(2) Position visor lamp in visor and press into
place.
DOME/READING LAMP
REMOVAL
(1) Insert a flat blade screwdriver in slot at the
center of the lamp housing. Rotate screwdriver
upward and unsnap dome lamp lens.
(2) Pull lens downward. Remove it from lamp
housing.
(3) Remove the lamp housing retaining screws
(Fig. 7).
(4) Push housing forward and release housing
from bracket.
(5) Disconnect wire harness connectors.
(6) Remove lamp housing from headliner cavity.
INSTALLATION
(1) Position dome/reading lamp housing at head-
liner cavity.
(2) Connect wire harness connectors.
(3) Locate rear pods of the lamp in the slots of the
dome lamp bracket. Push lamp housing up and to
rear.
LAMPS
Fig. 6 Underhood Lamp
HOOD WIRING LAMP
8L - 15