Set Lamp - Jeep 1997 Grand Cherokee Service Manual

POSITIVE CABLE FWD OILED WASHER NEGATIVE CABLE FELT
ZG
REMOVAL AND INSTALLATION (Continued)
(6) Unplug the headlamp or park lamp relay from
the junction block.
(7) Install the headlamp or park lamp relay by
aligning the relay terminals with the cavities in the
junction block and pushing the relay firmly into
place.
(8) Connect the battery negative cable.
(9) Test the relay operation.
(10) Install the right cowl side trim and the fuse
access panel.
HORN RELAY
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the cover from the Power Distribution
Center (PDC) (Fig. 12).
Fig. 12 Power Distribution Center
(3) Refer to the label on the PDC for horn relay
identification and location.
(4) Unplug the horn relay from the PDC.
(5) Install the horn relay by aligning the relay ter-
minals with the cavities in the PDC and pushing the
relay firmly into place.
(6) Install the PDC cover.
(7) Connect the battery negative cable.
(8) Test the relay operation.
POWER TION CENTER DISTRIBU-

SET LAMP

WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS,
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
cable.
stick, pry the cowl top trim panel off of the instru-
ment panel top pad (Fig. 13).
far enough to unplug the wire harness connector
from the solar sensor, or to remove the solar sensor
from the cowl top trim between the passenger side
and center defroster outlets.
cle.
theft security system set lamp mounting screw near
the driver side defroster duct outlet.
harness connector and remove the lamp.
VEHICLE THEFT/SECURITY SYSTEMS
REFER TO
WHEEL,
(1) Disconnect and isolate the battery negative
(2) Using a wide flat-bladed tool such as a trim
Fig. 13 Cowl Top Trim Remove/Install
(3) If the vehicle is so equipped, pull the panel up
(4) Remove the cowl top trim panel from the vehi-
(5) Remove the auto headlamp light sensor/vehicle
(6) Pull the lamp up far enough to unplug the wire
(7) Reverse the removal procedures to install.
GROUP 8M - PASSIVE
STEERING COLUMN,
COWL TOP TRIM PANEL INSTRUMENT PANEL
8Q - 9
OR