Breakaway Cable Attachment - Jeep Compass Operating Information Manual

Weight-Distributing Hitch
A weight-distributing system works by applying
leverage through spring (load) bars. They are
typically used for heavier loads to distribute
trailer tongue weight to the tow vehicle's front
axle and the trailer axle(s). When used in accor-
dance with the manufacturer's directions, it pro-
vides for a more level ride, offering more con-
sistent steering and brake control thereby
enhancing towing safety. The addition of a
friction/hydraulic sway control also dampens
sway caused by traffic and crosswinds and
contributes positively to tow vehicle and trailer
stability. Trailer sway control and a weight dis-
tributing (load equalizing) hitch are recom-
mended for heavier Tongue Weights (TW) and
may be required depending on vehicle and
trailer configuration/loading to comply with
Gross Axle Weight Rating (GAWR) require-
ments.
WARNING!
• An improperly adjusted Weight Distributing
Hitch system may reduce handling, stabil-
ity, braking performance, and could result
in a collision.
• Weight Distributing Systems may not be
compatible with Surge Brake Couplers.
Consult with your hitch and trailer manu-
facturer or a reputable Recreational Ve-
hicle dealer for additional information.
142

Breakaway Cable Attachment

European braking regulations for braked trailers
up to 7,700 lbs (3 500 kg), require trailers to be
fitted with either a secondary coupling or break-
away cable.
The recommended location for attaching the
normal trailer's breakaway cable is in the
stamped slot located on the sidewall of the hitch
receiver.
With Attachment Point
• For detachable tow bar pass the cable
through the attachment point and clip it back
onto itself or attach the clip directly to the
designated point.
Detachable Ball Clip Loop Method
• For fixed ball tow bar attach the clip directly to
the designated point. This alternative must be
specifically permitted by the trailer manufac-
turer since the clip may not be sufficiently
strong for use in the way.
Fixed Ball Clip Loop Method
Without Attachment Points
• For detachable ball tow bar, you must follow
the recommended manufacturer or supplier
procedure.
Detachable Ball Neck Loop Method
• For fixed ball tow bar, loop the cable around
the neck of the tow ball. If you fit the cable like
this, use a single loop only.