Jeep 1997 Grand Cherokee Service Manual page 395

MOUNTING SCREWS
ZG
REMOVAL AND INSTALLATION (Continued)
(2) Remove the three screws that secure the
Graphic Display Module (GDM) or Vehicle Informa-
tion Center (VIC) to the instrument panel armature
(Fig. 12).
Fig. 12 Graphic Display Module and Vehicle
Information Center Remove/Install
(3) Pull the GDM or VIC unit out from the instru-
ment panel far enough to unplug the wire harness
connector.
(4) Remove the GDM or VIC from the instrument
panel.
(5) Reverse the removal procedures to install.
GLOVE BOX LAMP AND SWITCH
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Remove the glove box module as described in
this group.
(2) From the back side of the glove box module,
squeeze the retaining tabs on the glove box lamp and
switch housing together and push the unit out the
front of the module through the mounting hole (Fig.
13).
(3) To install the glove box lamp and switch unit,
insert the unit through the mounting hole from the
front of the glove box module and push in on the unit
firmly, until the retaining tabs snap into place.
(4) Reverse the remaining removal procedures to
complete the installation.
GROUP 8M - PASSIVE
BEFORE ATTEMPTING
STEERING COLUMN,
LATCH STRIKER GLOVE
INSTRUMENT PANEL SYSTEMS
Fig. 13 Glove Box Lamp and Switch Remove/Install
GLOVE BOX LATCH STRIKER
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER
RESTRAINT SYSTEMS
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Remove the glove box module as described in
this group.
(2) From the top of the glove box module,
straighten the two mounting tabs that secure the
striker to the module (Fig. 14).
OR
Fig. 14 Glove Box Latch Striker Remove/Install
(3) Pull the latch striker out from the upper glove
box opening.
(4) To install the latch striker, insert the mounting
tabs through the slots in the upper glove box opening
and bend the tabs over from the top of the glove box
module.
BOX MOUNTING TABS LAMP SWITCH AND GLOVE BOX MODULE
TO GROUP 8M
BEFORE
STEERING
GLOVE BOX MOD- ULE
8E - 29
- PASSIVE
ATTEMPTING
COLUMN, OR