Jeep 1997 Grand Cherokee Service Manual page 502

CONSOLE LENS
8L - 12 LAMPS
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Insert the replacement bulb in the lamp base
socket. Rotate it clockwise.
(2) Connect the wire harness connector to the
lamp.
VISOR VANITY LAMP BULB
REMOVAL
(1) Using a small flat blade, carefully pry each cor-
ner of lens outward from lamp.
(2) Separate lens from lamp.
(3) Grasp bulb and pull outward.
INSTALLATION
(1) Position bulb in socket and push into place.
(2) Position lens on lamp and snap into place.
OVERHEAD CONSOLE READING LAMP BULB
REMOVAL
(1) Insert a flat blade screwdriver in slot at front
of lens (Fig. 4).
(2) Rotate the screwdriver until lens snaps out of
the housing.
(3) Remove lens from housing.
(4) Remove bulb from terminals.
Fig. 4 Overhead Console Reading Lamp Bulb
INSTALLATION
(1) Insert bulb into reading lamp terminals.
(2) Replace lens by holding lens level and pushing
rearward into housing.
(3) Push lens up to snap into housing.
FLAT BLADE
DOME LAMP BULB
REMOVAL
(1) Insert a flat blade screwdriver in slot at front
of lens.
(2) Rotate the screwdriver until lens snaps out of
the housing.
(3) Remove lens from housing.
(4) Remove bulb from socket.
INSTALLATION
(1) Insert bulb into reading lamp terminals.
(2) Replace lens by holding lens level and pushing
rearward into housing.
(3) Push lens up to snap into housing.
READING LAMP BULB
REMOVAL
(1) Insert a flat blade screwdriver in slot at front
of lens.
(2) Rotate the screwdriver until lens snaps out of
the housing.
(3) Remove lens from housing.
(4) Remove bulb from terminals.
INSTALLATION
(1) Insert bulb into reading lamp terminals.
(2) Replace lens by holding lens level and pushing
rearward into housing.
(3) Push lens up to snap into housing.
DOOR COURTESY LAMP BULB
REMOVAL
(1) Remove door trim panel. Refer to Group 23,
Body Components for service procedure.
(2) Remove bulb socket from lamp.
(3) Pull bulb from socket.
INSTALLATION
(1) Position bulb in socket and press into place.
(2) Install bulb socket in lamp.
(3) Install door trim panel.
CARGO LAMP BULB
REMOVAL
(1) Insert a flat blade screwdriver in slots provided
at lower portion of lens.
(2) Rotate screwdriver upward until lens snaps out
of housing.
(3) Remove lens from housing.
(4) Remove bulb from bulb socket.
INSTALLATION
(1) Position bulb in socket and press into place.
(2) Insert upper tabs of lens into lens housing.
(3) Snap lower portion of lens into slots at lens
housing.
ZG